NOTE: The Master Code and a PIN need to be set before the gate operatorĬan be programmed. Or if user tries to program a PIN already programmed in the memory. NOTE: An error tone will sound if the maximum number of PINs is exceeded Exit Program Mode| #| Keypad backlight will turn offĠ1 # (New 4-digit PIN) # Repeat (new 4-digit PIN) # Recommended to change and record your unique Master Code.Ġ9 # (New 6-digit Code) # (New 6-digit Code) #ģ. A Master Code is required (factoryĭefault code: 888888) to operate the Wireless Commercial Keypad. Prevent unauthorized access to the system. The keypad will exit the programming mode. The keypad will remain in programming mode. Programming mode, if an invalid code is entered, an error tone will sound, but The keypadīacklight will remain on if the product is in programming mode. Of the programming steps below unless otherwise indicated. The Wireless Commercial Keypad must be put into programming mode prior to any Reattach the faceplate to the mounting plate and lock with the key.Install the battery (provided) and re-install inner cover. Remove the battery cover using a Phillips screw driver.Mount the mounting plate to the desired surface and secure with 1/4″ screws or bolts (not provided).Unlock and remove the faceplate from the mounting plate.The mounting location needs to be in line of sight of the moving gate. Locate the keypad at least 6 feet (1.8 m) away from any moving part of the gate and where the user cannot reach over, under, around or through the gate to operate the controls. Choose a mounting location suitable for your application such as a wall, flat surface, or a pedestal with a 3″ x 3″ mounting pattern (LiftMaster gooseneck pedestal post models PED42 or PED64).WARNING: This product can expose you to chemicals including lead, whichĪre known to the State of California to cause cancer or birth defects or other NEVER permit anyone to cross path of moving gate or door. ALWAYS keep gate or door in sight until completely closed. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |